Black Friday 15% Non Variant

The ultimate upgrade for a Blumat system. The Mini Pump Kit converts your gravity-fed setup into a pressurized irrigation system — faster sensor response, more consistent moisture levels, and the freedom to run a large reservoir on the ground without elevation. Once you run Blumat on pressure, it's very hard to go back. Why Pressure Changes Everything ＋ Blumat systems are pressure-sensitive. Gravity setups can work well, but they often introduce slow response times and small inconsistencies. When you switch to pressure, the entire system tightens up: Faster sensor response to soil moisture changes Adjustments show results much more quickly More consistent moisture levels across your grow More reliable overall system performance What's Included ＋ Mini pump Expansion / pressure tank Adjustable pressure reducer with integrated gauge Inline filter Bulkhead fitting for reservoir connection All tubing and hardware to connect to your reservoir Adapter for 8mm tubing or 1/2" black poly via Perma-Loc fitting System Size & Capacity ＋ Ideal for small tents and home grows Scales to multi-tent setups Rated for up to approximately 50 gallons per day Suitable for larger rooms when properly designed Frequently Asked Questions ＋ Do I need a pump for a small Blumat system?No — but even small systems benefit from faster response and more consistent performance when running on pressure. Can I use a larger reservoir with this system?Yes. One of the biggest advantages is being able to run a large reservoir on the ground instead of elevating it. What's the benefit of switching from gravity to pressure?Faster sensor response, more stable moisture levels, better system control, and reduced maintenance.

Read more less

Full control over your Blumat system pressure. Adjustable from 2–14 PSI with a built-in gauge so you always know exactly what your system is running — the most important number to know in any Blumat setup. Key Features ＋ Built-in 0–30 PSI pressure gauge for real-time monitoring High flow rate of over 5 gallons per minute — can replace six or more standard Blumat pressure reducers Adjustable from 2–14 PSI to match any distribution method (drippers, drip rings, BluSoak) Powerful enough for the largest systems, precise enough for single-zone setups Connections & Adapters ＋ The reducer body has a ½" male pipe thread (MPT) inlet and a ¾" female pipe thread (FPT) outlet. Included adapters make it easy to install: Input — ¾" PVC swivel adapter for standard garden hoses or hose bibs Output — ¾" to ½" Perma-Loc fitting for Trunk Line Kits Output — ¾" to 8mm adapter for Supply Line Kits with SuperFlex tubing Also includes — ¾" FPT tee and 1/4" to ¾" MBT bushing Installation Instructions ＋ Tape all male fittings with the provided tape, wrapping 5–6 times clockwise. Assemble parts as pictured in the instruction diagram. Connect to a valve on a pump kit or to a hose bib using the provided ¾" swivel adapter. Using the provided fittings, connect to your Blumat system supply line. Open the incoming water to check current system pressure. Recommended ranges: Drip rings — 12–15 PSI BluSoak — 7–10 PSI To adjust pressure: turn off incoming water, release system pressure by opening a valve on the Blumat supply line until the gauge reads 0, then turn the black adjustment collar (tighten for more pressure, loosen for less). Close the Blumat supply line valve and open incoming water to re-pressurize. Check the gauge. If not in range, repeat steps 6–7 until correct.

Read more less