Official Blumat Distributors For The U.S. Since 1981

Brand-Ambassador-1500x120-px.jpg__PID:3dc5f7ff-7b49-45d9-ad8f-3e0cf380c12d

DIY Garden: Water Source

3 products


  • 8mm BULKHEAD / Through-Hull Tank Connector-1

    Blumat 8mm Bulkhead

    1 review

    Description UNIVERSAL: Convert rain barrels, water tanks, or any other container into a Blumat reservoir SIMPLE: Drill a hole (using 1/2" bit) into your container, and install the nipple facing outward 8MM OUTPUT: Integrate directly to 8mm flex line or other Blumat-compatible water supply tubing DURABLE: Built to last by the same company bringing you Blumat watering stakes FLEX-COMPATIBLE: Ideally suited for the flex tubing included with most Blumat systems Connect a Blumat system to a rain barrel or water storage tank. Just screw half on the inside of the tank, the other on the outside. The nipple connects to the standard 8mm Blumat water supply/feed line. You can either start with one of these bulkheads, or a Blumat Pressure Reducer, either of these fittings will "start" your Blumat watering system. Use 1/2" drill bit to puncture hole. These bulkheads will work flawlessly with your Blumat. They are easy to install, durable, perfectly fitted for other Blumat equipment, and can instantly turn any container of your choice into a perfect Blumat reservoir. These can also be used with drip irrigation lines and many other kinds of irrigation equipment. As long as you have 8mm tubing to attach to the nipple this bulkhead will do the trick. We use these on rain barrels, 5-gallon buckets, plastic totes, 55-gallon drums, and every other water vessel/container that you could imagine! After installing one or two, you'll be ready to run your Blumat system. To attach 8mm Blumat water supply line to a rain barrel or water storage tank. This is your classic bulkhead fitting, made in Austria, high quality and efficient for a Blumat system. Bulkhead fittings allow you to penetrate through a wall or barrier, while allowing passage within the fitting. This allow you to tap into a tank of water, while allowing water to pass-through the bulkhead fitting, and into a water supply line. We have these pre-drilled into our 5-gal bucket reservoir, see related products below. Have your own reservoir? No problem, simply drill 1/2" holes into your own water tank and convert it into a Blumat Reservoir. We have even higher quality bullhead fittings, some that stop water flow when disconnected. Check out our bulkhead fittings category. This is the bulk version of this item, so doesn't come with packaging for stores (makes it less-expensive for your convenience). *Reservoir not included, look into Blumat Reservoir or 5-gal bucket if you need a reservoir

    $5.50

  • 5-Gallon Reservoir w/8mm Bulkhead

    $38.00

  • 5-Gallon Reservoir w/8mm Bulkhead and Float Valve

    5-Gallon Reservoir w/8mm Bulkhead and Float Valve

    Description An easy and economical way to  automate a Blumat and/or BluSoak system. Just attach this to a 24/7 garden hose and gravity will take care of the rest.  For small systems, this is a simple way of controlling your pressure without needing an expensive pressure regulator - just make the reservoir higher for more water, lower for less.  The included fittings give you a choice of connecting to your water supply line with either a 1/2" male pipe thread or a 3/4" FHTIf your water source has over 50 psi pressure, add this (or similar) high quality but inexpensive pressure reducer: IG16309.  

    $60.00

Login

Forgot your password?

Don't have an account yet?
Create account