Black Friday 25% Variant
Blumat Clear Globe Sets
Not as elegant as our Glass Globe version and doesn't give out as much water; but, this one costs less than half as much and can really help your plants. Depending on temperature, potting mix and plant type; it typically goes about 5 days before needing to be filled up again. These water slowly and the slower you water, the deeper the water goes, the deeper the roots go, and the more access plants have to moisture and nutrients. The stronger and more healthy they become and the more resistant to under-watering, over-watering, and to pests.
$11.02 - $28.05
Irritec USA High-Pressure BluSoak Drip Tape
High-Pressure BluSoak Drip Tape is a low-flow, emitter-style drip tape designed specifically for pressurized Blumat irrigation systems. With 6-inch emitter spacing, it delivers deep, even hydration and consistent wicking throughout the soil profile. ⚠️ Not compatible with gravity systems — requires 10–15 PSI to operate correctly. This is the tape we trust for consistent, high-performance Blumat irrigation. What Makes BluSoak Different BluSoak may look like standard drip tape, but performance comes down to flow rate and emitter spacing—and this tape was selected very intentionally. Low-flow output matched to Blumat sensor behavior 6-inch emitter spacing for continuous lateral wicking Even moisture distribution across beds and containers Designed specifically for pressurized Blumat systems After extensive testing, this is the only drip tape we’ve found that consistently performs the way a high-pressure Blumat system is meant to work. How It Performs When run at proper pressure, BluSoak delivers stable, predictable moisture across the entire root zone. Uniform hydration without dry spots No channeling or uneven watering Minimal runoff when properly set up Consistent performance across the full length of the tape This creates a balanced moisture environment that supports healthy roots and consistent plant growth. Pressure Requirements This tape is designed for pressurized systems only. Operating range: 10–15 PSI Ideal with 1-bar (15 PSI) or adjustable pressure reducers Works with pump systems or municipal water sources Gravity systems will not provide enough pressure for proper operation. Available Lengths 10 ft 20 ft 40 ft 100 ft rolls Installation Notes Cut through emitters, not between them. Cutting between emitters can disrupt spacing and lead to uneven or non-functional distribution. Always cut directly through an emitter to maintain proper performance. Ensure all Perma-Loc fittings are fully tightened. For best results, hold the black body of the fitting with pliers or channel-locks, then tighten the green collar by hand until snug. This typically provides an additional ¼ turn compared to hand-tightening alone. Even small leaks can reduce pressure and flow where it matters most, leading to inconsistent watering and reduced Blumat performance. Why Growers Choose BluSoak Clog-resistant design proven in commercial grows Consistent flow and spacing across the entire run Reliable performance under pressure Improved uniformity compared to standard drip tape Excellent value for both small and large systems
$6.00 - $32.40
8mm Superflex Supply Line Kit
The foundation of any Blumat irrigation system. Pre-cut kits of 8mm SuperFlex tubing — kink-resistant, flexible, and ready to run from your water source to your sensors. Available in 25 ft, 50 ft, and 100 ft. What's Included ＋ 25 ft, 50 ft, or 100 ft of 8mm SuperFlex tubing 4 × 8mm Tees 3 × 8mm Shut-Off Valves Coverage by Kit Size ＋ 25 ft kit — up to 25 square feet 50 ft kit — up to 50 square feet 100 ft kit — up to 100 square feet
$54.00 - $140.40
What Growers Are Saying
